Question:
Computer resets itself please identify (diagnose) problem.....???
Andrew
2006-11-28 21:59:19 UTC
Please help me...my computer all of a sudden shuts down itself and keeps on turning on and off...even without the hard drive it still goes on for a second and then resets and then goes on and then resets and one time when the hard drive was in it reset during the loading of windows and fried the hard drive...even after formatting it on a seperate computer it was too fried..
.back to the resetting computer...it isn't the power supply because i replaced it with a new one thinking it was the problem but it isn't it still resets...please help!?
Nine answers:
anonymous
2006-11-29 08:23:01 UTC
If your computer is not working properly while you are working on it, it could be a problem with device drivers, hardware or software.

Detailed instructions at http://tinyurl.com/yk5zpr
Vince
2006-11-28 22:07:13 UTC
Most modern computers have temperature sensors on the motherboard and CPU. If the temperature on the motherboard, CPU or sometimes even inside the case gets to a pre-determined temperature, the computer will shut itself off as a self-preservation mechanism. It seems to me that one of these sensors might be fried. However, before messing with your BIOS, open the case and make sure that you blow all of the dust and lint out of all of the openings on the case, as well as any dust or lint that might be lying around inside your computer (perhaps on your heat sinks?) If this doesnt help, then you might be able to edit your BIOS. Depending on your computer, you might be able to get into the BIOS configs and override it. When you switch your computer on, hit either delete or escape (depending on the brand of your computer, it might even be some other key) and you should get a list of options. Find the one that says 'thermal protection' or something along those lines and toggle it to off.



Hope this helps.,

Vince
Mad Scientist
2006-11-28 22:22:33 UTC
To help diagnose the problem listen to the beeps...



No Beeps Short, No power, Bad CPU/MB, Loose Peripherals

One Beep Everything is normal and Computer POSTed fine

Two Beeps POST/CMOS Error

One Long Beep, One Short Beep Motherboard Problem

One Long Beep, Two Short Beeps Video Problem

One Long Beep, Three Short Beeps Video Problem

Three Long Beeps Keyboard Error

Repeated Long Beeps Memory Error

Continuous Hi-Lo Beeps CPU Overheating
MegaNerd
2006-11-29 00:32:08 UTC
When you are ready to buy a new system, go to www.stupidcheapcomputers.net. I buy all of my stuff from them, and everything is Vista ready.



Microsoft is about to release its latest operating system, Vista, in January. It’s going to make all of these “bargain” computers nothing but JUNK as soon as it’s released. The reason that you are seeing so many cheap systems on the market right now is because a lot of them CAN’T RUN Vista and the merchants are trying to dump them as hard and fast as they can before Vista shows up and everyone learns what a piece of crap they were sold for $500 (or whatever).



Anyway, I bought a complete, new system from stupidcheapcomputers.net with a warranty for LESS than it would cost me to build it myself or order a custom one from the manufacturer. You can use my frequent buyer code: ATX926. That will get an additional 10% discount at checkout.



I have NEVER had any problems with anything that they have sold me and their customer service is outstanding. Those guys blow my mind.



Good luck!
liv
2016-10-04 16:17:04 UTC
first of all your laptop can no longer carry out a production facility reset without you pressing or understanding something. 2d, Norton is crap. it won't safeguard you from viruses, its an quite susceptible application. decide for something like AVG or Bullguard. Now approximately those archives. you will have the potential to accomplish a device fix by going into upload-ons then device. If no longer you are able to take your workstation to a restore save and that they might have the potential to extract your lost archives. in case you havn't pressed something then Im enormously specific your laptop hasnt completed a production facility reset. confirm your rigidity is connected exact and take a verify out restarting your workstation. If no longer take it to a restore save.
anonymous
2006-11-28 22:09:42 UTC
Did you run a memory scan by chance? It's completely possible that what was once pefectly fine memory chips somehow went funky and caused the computer to crash and reboot every time it scanned it on bootup. At what point does the computer get to before it reboots itself?
Douglas G
2006-11-28 22:06:44 UTC
check to see if the temp of the cpu and the video card is too high touch the heat sinks them may be plugged with dust
jalal_aljabry
2006-11-28 22:08:53 UTC
if problem hardware:

first check of restart and on/off button

then make shore from RAM may have problem

else:

check for virus on hard or in motherboard(BIOS)
anonymous
2006-11-29 03:16:28 UTC
system registry problem...missing DLL file..use a recovery program dude


This content was originally posted on Y! Answers, a Q&A website that shut down in 2021.
Continue reading on narkive:
Loading...